Many US buyers assume that JDM engines come with low mileage because Japanese owners scrap their cars young. The official figures do not support that story. The better explanation starts with how little Japanese owners drive. In its 2021 passenger car survey, the Japan Automobile Manufacturers Association (JAMA) found that the main driver of a household car covers about 370 km a month on average, roughly 230 miles. The US Federal Highway Administration reports an average of 13,735 miles per licensed driver in 2024. That gap explains much of what buyers value in JDM engines, and it is the right place to start before following the cars through auctions, exports and dismantling.
Why JDM engines arrive with fewer miles on them
The arithmetic is simple, though it rests on averages. At 370 km a month, a car covers about 4,440 km, or roughly 2,760 miles, in a year. At that pace it needs more than 20 years to reach 65,000 miles. An average US driver passes that mark in under five years. These are population averages, not a record of any one engine, but they show why a Japanese engine from a Toyota or Honda can come from a car with a low odometer reading, and why low mileage is common among used engines from Japan. JAMA also reports that shopping, errands and similar trips are the main use for about 42% of drivers, which points to short, slow trips rather than sustained highway running.
US importers build their pitch around this gap. The Dallas-based importer behind texasjdmmotors.com says its engines are sourced from Japan with less than 65,000 miles, and it ships to the lower 48 states. An average is not a guarantee for any single engine, though. A buyer still needs to check the mileage and condition of the engine in each listing and ask whether it was tested.
Everyday traffic at an intersection in Machida, Tokyo. Photo: MASA KUROFUNE, CC0, via Wikimedia Commons
Shaken, taxes and the price of keeping an older car in Japan
A new private passenger car receives an inspection certificate valid for three years from the Ministry of Land, Infrastructure, Transport and Tourism (MLIT). After that, the renewal inspection, called shaken, comes every two years. Each renewal requires the car to pass a mandatory check before it can stay on the road, and each one is another bill for the owner. JAMA’s 2023 survey found that about 80% of owners feel burdened by the cost of shaken.
Taxes add to the pressure. The Ministry of Finance sets the weight tax for a private passenger car at 4,100 yen per 0.5 metric ton per year under 13 years, rising to 5,700 yen after 13 years and to 6,300 yen after 18 years. For a 1.5-metric-ton car, the annual figures are 12,300, 17,100 and 18,900 yen. Under MLIT’s green tax scheme, automobile tax is raised by about 15% for gasoline and LPG cars more than 13 years after first registration, and for diesel cars more than 11 years after first registration. Electric vehicles and hybrids are excluded. JAMA’s survey puts the average ownership period of a household car at 7.2 years, and over 20% of owners keep a car for more than 10 years.
These costs give owners a reason to sell or trade in a car rather than keep it indefinitely.
The scrapped-at-seven story does not hold up
Many sellers repeat the claim that Japanese cars are scrapped at five to seven years old. The official numbers point the other way. AIRIA, the Automobile Inspection and Registration Information Association, puts the average number of years passenger cars remain in use, excluding kei cars (the small category with tight engine and size limits), at 13.35 years as of March 2025. Cars taken in as end-of-life vehicles in fiscal 2024 averaged 17.0 years in age, according to the Ministry of the Environment and the Ministry of Economy, Trade and Industry (METI). Some 2.56 million such vehicles were taken in that year, down from 2.73 million in fiscal 2023. For comparison, the average age of end-of-life vehicles was 12.0 years in fiscal 2005.
The 7.2-year figure measures something else. It shows how long the first household keeps a car, not how long the car lives. Used engines therefore reach the market through a chain of owners, auctions and exports.
From the auction lane to the port
USS, Japan’s largest auto auction operator, reported 3.50 million vehicles consigned and 2.34 million contracts completed in fiscal 2025. It runs 19 physical auction sites and assigns one of 10 grades to each vehicle based on its own inspection. More than 50,000 vehicles go up for auction each week on average, and each one takes about 20 seconds on the block. That volume lets JDM cars change hands quickly.
Before a car can be exported, its owner must obtain a temporary export deregistration from MLIT, which requires returning the car’s license plates and inspection certificate.
Japan exported 1,573,479 used vehicles in 2024 and 1,714,279 in 2025, according to e-Stat trade statistics compiled by jumv.net. Cars that are not resold go to dismantlers registered under the Automobile Recycling Law. At the end of fiscal 2024, there were 4,081 registered dismantlers. METI notes that they take end-of-life cars apart and reuse parts such as engines and hoods. That reuse is the second source of JDM engines.
Some engine codes carry strong reputations among enthusiasts. Nissan’s RB20, RB25 and RB26DETT engines, shown at the Prince and Skyline Museum in Okaya, Nagano, are examples.
Nissan RB20, RB25 and RB26DETT engines at the Prince and Skyline Museum in Okaya, Nagano. Photo: 先従隗始, CC0, via Wikimedia Commons
What a US buyer should check before buying JDM engines
On the US side, the Environmental Protection Agency (EPA) says its emission standards apply to all vehicles and engines, including imported ones, whether new or used. Importers declare engines to US Customs and Border Protection on EPA forms, such as Form 3520-1 for light-duty vehicles and their engines.
The Dallas importer’s site lists engines under Acura, Honda, Infiniti, Lexus, Mazda, Mitsubishi, Nissan, Subaru and Toyota, and many listings also show an engine code. A buyer, including one planning an engine swap, should start with the engine code and check the rest of the listing against it. A listing deserves a closer look in several areas:
- Engine code: confirm that the code matches the vehicle. Codes such as Lexus 3UZ-FE, Honda R18A, Subaru EJ257, Subaru FA20, Mitsubishi 4B11T and Nissan MR16DDT appear on US importer listings, so the code should be checked against the engine itself.
- Long block or complete engine: ask which form the engine ships in, and whether the intake manifold, ECU and wiring come with it. Ask whether a transmission is included as well.
- Compression test: ask whether the engine was compression tested and request the result.
- Mileage: the listed figure is the seller’s number. Japanese odometers read in kilometers, so ask whether the figure was converted to miles and, if so, how.
- Inspection: a label such as “Inspected” describes the seller’s process, so ask what that inspection covered and which parts it checked.
The short version
The supply of JDM engines is explained by light use, rising costs with age and an efficient auction-to-export system, and much less by young cars being crushed. Low mileage comes from owners who drive little, and the pipeline moves many cars that are still usable. Buyers in the US still need to verify each engine, because averages describe a population of cars rather than a single JDM motor.








